Connecting SBP (Fast Payment System) Payments

SBP payment can be connected in two ways:

• Generating a payment QR code on a Vendista terminal
• Generating a payment QR code on the machine screen

In both cases, you need to register and set up a Paymaster shop (an online payment-acceptance service). For registration and creating a shop and trade points, refer to the

. Attention! A separate trade point must be created in the Paymaster shop for each terminal or machine connected to SBP payment!

Generating a payment QR code on a Vendista terminal

Milkshaker model

In addition to connecting the Paymaster shop, the terminal cable must be modified — an extra wire with a connector must be soldered on. If you have a single terminal and it is in use, buy an additional cable.

For the modification you will need a single-core wire (1.5m) and an MF3-3.0 connector (in the photo below).

The MF3-3.0 connector is soldered to one end of the wire; the

connects to the

. A separate soldering scheme is used depending on the Vendista terminal model:

• Vendista 2G cable soldering scheme: https://wiki.vendista.ru/en/home/CableMDB_10pin
• Vendista RJ45 cable soldering scheme: https://wiki.vendista.ru/en/home/CableMDB_RJ45

Any work on the cable must be done with the machine powered off!

Route the prepared wire inside the machine and bring it out to the rear wall to connect it to the controller board.

Connect the connector to the indicated port on the controller board.

Start the machine, wait for the Vendista terminal to load, and send it these commands:

• "MDB.Timeouts": parameter #1 = 1800; parameter #2 = 30; parameter #3 = 90.
• "External pin settings (10th pin on the connector)": parameters #1-3 = 0; parameter #4 = 3.
• "Contactless payment modes": parameters #1 and #2 = 1.

To activate the payment module in the machine software, press:

⇒ ⚙️ ⇒ Payment devices ⇒ SBP. Select the SBP type "Vendista". Close the menu and make a test payment. ATTENTION! The QR code appears on the terminal only 5 seconds after the terminal enters payment mode!

Generating a payment QR code on the machine screen

Milkshaker model

ATTENTION! This payment method requires a stable internet connection on the machine. Transactions go directly through the Paymaster service. To set up this payment method you will need:

• Paymaster trade point number;
• Paymaster trade point secret key;
• Cloud cashbox ID (Nanokassa or Orange Data);
• Cloud cashbox token.

To activate the payment module in the machine software, press:

⇒ ⚙️ ⇒ Payment devices ⇒ SBP. Select the SBP type "Shaker". Fill in the empty fields with your data. Close the menu and make a test payment. If the payment QR does not appear on the machine screen when SBP payment is selected, check the entered trade-point number and key, make sure your Paymaster shop is ready and the trade-point data is not used elsewhere, and make sure the machine has a stable internet connection without dropouts.

This payment method can be tested using only the Paymaster trade point number and its password. If you leave the cloud-cashbox ID and token fields blank, the machine will generate an empty receipt after dispensing the drink.