Connecting to a Water Tank (Touch)

Connection rules and procedure:

1. Lower the pump to the bottom of the

   

   .
2. Set the

   

   to the lower position.
3. Turn the taps as shown in the

   

   .
4. Unwind the float line of the

   

   . The float must hang freely into the waste container, and the sensor must be in the

   

   .
5. Start the machine. After power is applied, the pump runs for 1-2 seconds. After the software loads, an Error 1 No Water message (see guide) appears on the screen.
6. Press the

   

   toggle and, on the machine screen, press "Water pumping".
7. The machine starts the system-fill process. Once the system is full, water begins to flow through mixer #1 and the hose into the drain container. Wait for the process to finish.

---

Setting the water level

1. Run the pumping and check the water level in the mixer funnel (use the picture below as a guide):

1. If the water level is insufficient or excessive, adjust the pump voltage. You will need a small flat screwdriver. Adjustment is done by turning the adjustment screw on the UPS board (rear wall of the machine):

1. To increase the water flow, turn the screw clockwise; to decrease it, counterclockwise. Check the water level in the funnel.
2. Open the service menu and flush the mixers by pressing buttons 1-4 on the screen in turn.
3. Press the

   

   service button. After the machine reboots, make sure Error 1 No Water is no longer shown.
4. After setting the water level, verify water dispensing in the service menu ("Calibration value").

Water supply setup is complete.