Replacing the Water Solenoid Valve (Shaker S)

ATTENTION! Replace the valve with the machine powered off!

You will need a thin flat screwdriver and a Phillips screwdriver. Remove the rear cover to access the valve group.

Replacement steps:

1. Remove the terminals from the faulty valve:

1. Unscrew the group's mounting screws:

1. Pull the group towards you:

1. Unscrew the valve's mounting screws:

1. Remove the connection clip:

1. Press the ring of the connection clip and pull out the tube towards you:

1. Press the clip ring on the other side and pull out the tube:

1. Remove the valve and connect the new one to the tubes and terminals:

1. Switch on the machine and check the valve's operation by running a mixer flush. Inspect the connections for leaks. If everything is done correctly, refit the valve group by following the steps in reverse order.