Replacing the Water Meter

You will need a Phillips screwdriver for the replacement. Replace the meter with the machine powered off.

Steps to access the meter:

1. Remove the

   

   ;
2. Unscrew the

   

   securing the dispensing window;
3. Unscrew the

   

   of the cup sensor;
4. Carefully pull the

   

   towards you and remove it.

The water meter is located on the cooler's outlet pipe:

ATTENTION! The meter model may differ from the one shown in the photo. Before replacing, check which meter is installed in your machine.

Before removing the meter, photograph its wiring. Note the position of the

.

To replace the meter:

1. Remove the

   

   of the meter connections.
2. Press the

   

   and pull the PVC hose out of the meter connection on both sides. ATTENTION! There may be a small amount of water inside the meter. Be careful not to let water reach the wiring.
3. Disconnect the meter

   

   .
4. When fitting the new meter, mind the

   

   .
5. Insert the PVC hose into the meter connection. Press the hose and push it in until the connection locks.
6. Pull the hose back slightly and fit the

   

   .
7. Reconnect the meter

   

   .

At this stage, check the meter connections for leaks. Switch on the machine and place a container under the pour hoses. Run the mixer flushes and inspect the water-meter connections. If leaks appear, switch off the machine and reconnect the PVC hoses to the connections.

When finished, reboot the machine with the CONTROLLER REBOOT button and run the water-dosing calibration.